Products & commissioning

Integrating the go-e Charger PRO (neoom edition) Charging Station

Updated on 22/11/2026

The charging station is configured via the app. The integrator must either have the app installed or use the app on the customer's smartphone.

go-e app configuration & integration into CONNECT

To integrate the charging station, the integrator must:

  • Update the charging station to the latest firmware (at least version V60.4 required)
    • From this firmware onwards, the required additional settings are set automatically by the neoom BEAAM.
    • After commissioning, you can additionally check the following settings:

In the go-e app under "Settings" activate the API access via

      • "Allow local Modbus TCP API" set to "ON"

and set the field

  • - - "Swap registers" to "ON"

and the item

      • "Swap bytes" to "OFF".
Integrating the go-e Charger PRO (neoom edition) Charging Station – Abbildung 1
  • If necessary, assign a static IP address to the charging station in the customer's router settings.
  • Then integrate the charging station into the neoom CONNECT site (connect.neoom.com) with the IP, port 502, unit ID 1 Menu item "Site configuration" --> click the + tile to add a new device. After saving, click "Apply configuration".
Note: Modbus TCP is enabled by default. After using the RESET card, you must re-enable it manually (see go-e Charger PRO (neoom edition): what needs to be reset after using the RESET card?).

Recommendation if the charging station is not in the BEAAM network: Set the IP statically, otherwise it can change within a few weeks and the station will be offline in neoom CONNECT / no longer reachable for the BEAAM.

So that our charging strategies, as shown below:

Integrating the go-e Charger PRO (neoom edition) Charging Station – Abbildung 2

are accepted by the go-e, the option "Basic charging - Basic" must be configured, see:

Integrating the go-e Charger PRO (neoom edition) Charging Station – Abbildung 3

More on Charging stations