Device integration › Charging stations

Connecting the Fronius Wattpilot

Updated on 20/11/2026

Which functions (for example surplus or fast charging) your model supports with neoom Ai is listed in the device compatibility list.

Image 1-2

Configure the Wattpilot in neoom Ai

Add device

Image 2-3

Fill in the fields

As Charger ID, enter the serial number of the Wattpilot.

As Connector ID, enter 1.

Connecting the Fronius Wattpilot – Abbildung 3

Then save and apply the configuration

Image 5-2

Now set the following in the Fronius app:

1.) Protocol: select "ws" instead of "wss".

2.) Host: As host, enter the IP address of the BEAAM, followed by a colon and 4000. (e.g.: 10.10.10.121:4000). You can find the IP address of the BEAAM in neoom Ai (connect.neoom.com) under site -> BEAAM information page, or directly on the web interface of the BEAAM.

Connecting the Fronius Wattpilot – Abbildung 5

3.) Path: As path, enter a slash (/) followed by the serial number of the Wattpilot. The serial number is shown on the Fronius Wattpilot type plate and in the Fronius Wattpilot app.

Then click Save/Apply.

Connecting the Fronius Wattpilot – Abbildung 6

If the values entered in the individual fields (protocol selection, host, path) are not transferred to the OCPP server address (⭐), you must enter them manually. To do this, click the "Clipboard" icon to the right of the address and enter the address manually using the following pattern: ws://IP-addressBEAAM:4000/serialnumber (e.g.: ws://10.10.10.121:4000/123456789

Connecting the Fronius Wattpilot – Abbildung 7

After saving, the Wattpilot should be online/connected immediately in the Fronius app and in neoom Ai.

More on Energy management (neoom Ai)